Custom Bamboo Pull Out Cutting Board (1/2", 3/4" or 1" thick)
Custom sizes up to 96" long (depth) and 48" wide
Available in darker amber color or natural blonde
Bamboo is durable and resists warping and rot
Cross layered bamboo for extra durability
Includes finger pull out
Made in USA

Replace your old under the cabinet cutting board with a long lasting bamboo pull out (also known as under the counter or breadboard). Typical pull outs boards are made with plywood or pine, which quickly stain, attract mold and become unsightly. Bamboo is a extremely durable material that is naturally resistant to water. Made from densely packed fibers, bamboo is not prone to warping, mold build up or staining. This makes bamboo low maintenance and a perfect replacement for your pull out.

Our bamboo is made from a triple layered sheet, that sandwiches a middle support layer of bamboo between an exposed edge grain surface, providing maximum durability. This makes for a cutting board that is both attractive and highly functional.

All of our pull outs come with a routed finger groove to easily pull the board out. Juice groove options are also available if you often cut meats or fruits and don't want liquids running off the board.

Lead time is usually 5 to 7 business days for production, plus shipping time.

Measuring Instructions

If you still have the existing pull out board, we recommend that you use that for your measurements for long side, short side and thickness. We will build your board to your exact dimensions, so do not worry about tolerances if your existing pull out fits well.

If you do not have the existing pull out, here is how you should measure for your replacement:

Board Depth: Measure from the front of the cabinet (right at the overhang) to the of the back of the cabinet or wall. Subtract 1/4" (this helps hide the pullout under the overhang) and this is your board depth. (Typically this will be the long side measurement)
Depth Fraction: If your board depth is 15-3/4", then you would put 15" for board depth and 1/2" as your depth fraction.
Board Width: Measure slot from side to side, where the pull out board would fit. Subtract 1/8" from measurement, so that board can slide in an out easily and is not too tight. (Typically this will be the short side measurement)
Width Fraction: If your board width is 15-3/4", then you would put 15" for board width and 1/2" as your depth fraction.
Edging/Corners: Please see diagram below for difference between Standard and Bullnose. Standard is recommended by default.
Juice Groove: Also known as a juice well or moat, this is a groove that is routed into top side of the board to catch liquids and prevent spilling off the side. There is an added fee for this option.